One Table, One Team Where every seat matters.

Pay: $36-$39/hour

Shift: Rotational Shift, Monday-Friday

• 6am-3pm
• 8am-5pm
• 2pm-11pm
• 10pm-7am

Electronics Technician II

This position, under general supervision, is responsible for performing maintenance and troubleshooting of electrical, electronic and mechanical systems used in the plant.

Responsibilities:

• Perform PMs, inspections and verifications on all control components and apply appropriate corrective action.
• Replaces, troubleshoots, repairs, installs and adjusts accompanying equipment to perform as designed.
• Ability to safely work with and troubleshoot systems at varying voltages (voltage electrical systems including 110V, 220V, and 480V) in accordance with electrical codes and safety procedures.
• Performs frequency drives, writes drive logic in PLC code, creates HMI applications uploads and downloads PLC programs and HMI applications, programs ladder logic to troubleshoot equipment, integrates new processes into equipment, sets up network communications and sets up advanced routing of Ethernet protocols.
• Calculates resistance, loads, currents and component sizes appropriate to the application. Calibrates instruments to control or record accurately.
• Performs periodic inspections of all scales, meters, controllers, recorders, and any other measuring devices used in the production of product or in facility support systems.
• Reads and interprets schematic drawings and diagrams required to perform maintenance on, or install plant equipment.
• Responsible to conduct yourself and ensure your subordinates (if applicable) conduct themselves in a manner consistent with company mission, values, code of ethics, policies, and other standards of conduct.

Preferred Qualifications:

• Education: Associates degree or equivalent experience.
• Years of Related Experience: 2+ years of experience preferably in a food manufacturing environment

Knowledge/Skills/Abilities:

• Working knowledge of low to high voltage electrical systems including 110V, 220V, and 480V.
• Advanced electrical and maintenance knowledge/experience required; Must be able to work with electrical and electronic assemblies, draw and read electrical schematics;
• Must have skills sufficient to design and implant control circuits utilizing PLCs, HMI, VFDs and Servos; Computer skills sufficient to operate a laptop/PLC and HMI programming software such as Allen Bradley, Square D, Siemens, Omron and SAP maintenance module
• Ability to read and interpret documents such as safety rules, operation manual and maintenance instructions, and procedure manuals
• Ability to complete work orders, carry out instructions furnished in written, oral or diagram form, and complete required paperwork
• Electrical knowledge and ability to expand knowledge and skills via on-the-job and as mandated by management, including all required OSHA training
• Ability to comply with all general safety policies and procedures in accordance with Company, Local, State and Federal Occupational Safety and Health Administration (OSHA) rules, USDA and regulations
• Ability to obtain a valid forklift license
• Must be able to lift fifty (50) lbs

This job description is not intended to be an exhaustive list of all duties, responsibilities and qualifications associated with the job. An individual must be able to perform all of the duties and responsibilities listed in a fully competent manner to be considered successful in the job. Reasonable accommodations may be made to enable individuals with disabilities to perform essential duties and responsibilities.